Started the oh so laborious task of re-sleeving my psu yesterday, the corsair sleeving isn't as dense as it could be and shows the cables inside, then there's the finish at either end....glue has seeped out everywhere and the sleeving doesnt go far enough along the cablesm, wasn't what I was expecting from them I must say, my HX620 was miles better!

So after stripping off the rubbish effort by corsair and removing all of the wires from the 24 pin connector, sorting them by number as I went, I then placed the ends of the wires into a piece of foam from the psu's box. Unfortunately I didn't have any sleeving big enough to take all 24 wires at once, so I instead split them down into two sets of 12, down to the last 8" or so where they will eventually all be sleeved individually. My thumb was hurting a fair bit after this from using the lighter so much!