Thought i would start on it today ....time to strip it down.







Got to remove the top fan for the H100i to fit, it's a 200 x 200 x 30 mm





Right this is where the fun begins.....i watched a review video of the G10 case last night and they reckoned the front 200 x 200 x 20 mm wasn't that good, they didnt write it off but said it Wasnt as good ast the top one which is a 30mm thickness instead of 20mm which got me thinking of adding it somehow to pull more air into the case....so this is what i came up with.....



I thought that would help the front fan pull more air in if it was positioned there.

I had to make something to chock it up a bit as it was sitting a tad low and another one to help support it onto the side of the case.



Added some double sided trim tape that you use for cars and some cable ties and its solid.